Specifications

Chassis Plans CPX1-241 Technical Reference Chapter 7 – LCD Operation
Page 30
Monochrome Mode 
- Color
- Red Monochrome
- Green Monochrome
- Blue Monochrome
- Red Only
- Green Only
- Blue Only
Backlight Setup
- B/L Invert : : Invert for the backlight brightness
- B/L Control : D/A / PWM : Selection for voltage level dimming control / PWM
dimming control
- Backlight Frequency : 100 ~ 440Hz in a step of 20
- Light Detector : : Enable ambient light detector function by using KIT
70220-3
Default Setting 
Reset to Factory Defaults  (Activate when JC1 position 4 sets open)
Are you sure ? Yes/No
Reset to Factory Defaults with (Color Temp.)  (Activate when JC1 position 4 sets open)
Are you sure ? Yes/No
Save Current Settings as Calibrated Values  (Activate when JC1 position 2 sets closed)
Are you sure ? Yes/No
Recall Stored Calibrated Values 
Are you sure ? Yes/No
* : DISPLAY IN VIDEO MODE ONLY
# : DISPLAY IN ARGB MODE ONLY
+ FUNCTION DISABLE WHEN KIT 70600-3 CONNECTED
++ DISPLAY WHEN KIT 70600-3 CONNECTED
Firmware V0.45.00.01 or up
Table 10 - LCD Controller OSD Menus