4

To control whether Compressor displays the Batch Template Chooser on startup
µ
Select Show Template Chooser to display the Batch Template Chooser on startup.
µ
Select Use Blank Template to not display the Batch Template Chooser on startup.
To control whether other computers with Share Monitor can view this computer’s job
status
µ
Select “Allow connections from other computers” to allow remote computers running
Share Monitor to monitor this computer’s job status.
The remote computer needs to know this computer’s IP address or hostname. (There is
no password.)
To enter IP addresses or ranges for remote host computers
1 Click Add (+) at the bottom of the Compressor Preferences window.
The host address dialog appears.
2 In the host address dialog, do one of the following:
• Select Host, complete the Host Name and IP Address fields, and click Add Host.
Note: You can also enter only the host name or the IP address and press the Tab key.
If a corresponding host name or IP address is found, the match is entered in the field
automatically.
• Select “Host IP address range,” complete the Range fields, and click Add Range.
The hosts or host ranges appear in the Host table in the main Preferences dialog.
Important: Any changes you make to the Compressor preference settings take effect
only when you click OK. If you make changes but decide not to use them, click Cancel.
76 Chapter 5 Setting Compressor Preferences