4.1

Chapter 3 Simple transcoding 14
5 To change the name of a le to be output, double-click its name in the Filename column, and
then enter a new name.
The default name assigned to each transcoded le is the source lename appended with the
extension of the format used during transcoding (.mov or .mp4, for example).
Note: If you see an alert icon to the left of the lename, the lename assigned to that output
row has already been used.
6 To view the properties of a setting, select an output row, and then open the inspector by clicking
the Inspector button in the upper-right corner of the Compressor window.
Depending on the setting you're viewing, general, video, and audio properties are displayed in
the inspector. For information about modifying these properties, see View and modify a setting’s
properties on page 20.
Add and remove job outputs
You can add additional transcoding instructions to a job by adding one or more output rows.
You can also remove output rows.
Do one of the following:
m To add an output row: Position your cursor over an output row in the job, and then click the Add
button that appears at the end of the row. Then, in the window that appears, select one or
more settings, choose a location, and click OK.
m To remove an output row: Position your cursor over the output row that you want to remove, and
then click the Remove button that appears at the end of the row.
67% resize factor