User manual

95.08.23.09.18

Color LaserWriter 12/600 PS Take Apart 3–159

Oil-Overﬂow Sensor (PS10) (page 5 of 6)

Note: For the following step, you will need a short Phillips screwdriver

no more than 3.5 inches (8.9 cm) in length.

5 Using the short screwdriver, remove the brass-colored screw and lift the

sensor mount plate away from the fuser.

Replacement Note: Be very careful to align the ﬂag on the actuator

with the slot in the bottom of the mount plate. Failure to do so could

result in oil-overﬂow conditions going undetected.

Sensor Mount Plate