User manual

95.08.23.09.17
Color LaserWriter 12/600 PS Take Apart 3–75
I/O Interconnect Shield (page 2 of 2)
2 Lift the shield and status panel housing and disconnect J803 on the I/O
interconnect board. Remove the shield and housing from the printer.
Replacement Note: Two small claws on the I/O interconnect shield
mate into slots in the chassis. If the left slot is not rectangular, you may
need to flatten the left claw prior to reinstallation to assure a tight fit
between shield and chassis. Note that there is a ribbon cable grounding
pad beneath the flange, so you will not get a familiar metal-to-metal fit.
J803
Right Slot
Left Slot