Operation Manual

• Click the left or right arrow in the Definition value slider to change the clarity of the
image by 5 percent increments, or drag in the value field.
• Double-click the number in the Definition value slider, then enter a value from 0.0 to
1.0 and press Return.
Use the Definition
slider and value slider
to add local contrast
to the image.
A value greater than 0.0 increases the clarity in the image. The definition in the image is
updated as you change the parameter value.
Adjusting Saturation in the Image
You can change the value for the Saturation parameter to either give your image an extra
burst of color or tone down the color palette by desaturating the image.
Before Saturation adjustment After Saturation adjustment
To change the saturation of an image
1 Select an image.
2 In the Enhance area of the Adjustments inspector or the Adjustments pane of the Inspector
HUD, adjust the Saturation parameter by doing one of the following:
• Drag the Saturation slider.
• Click the left or right arrow in the Saturation value slider to change the saturation of
the image by 5 percent increments, or drag in the value field.
515Chapter 17 Making Image Adjustments