Operation Manual

To delete a Spot & Patch target overlay
Do one of the following:
µ
Select a Spot & Patch target overlay in the image, then click the Delete button in the Spot
& Patch area of the Adjustments inspector or the Adjustments pane of the Inspector HUD.
Click the Delete button
to delete a Spot & Patch
target overlay.
µ
Command-click the Spot & Patch target overlay.
Command-click
a Spot & Patch target
overlay to delete it.
The Spot & Patch target overlay disappears.
Working with the Devignette Controls
You use the Devignette adjustment controls to correct a vignette that was applied to an
image as it was shot. The term vignette describes an image whose brightness fades to its
periphery from its center. Vignettes are usually caused by poor lens design, stacked filters,
lens hoods, and wide-angle zoom lenses. Aperture corrects the image by increasing the
brightness on the edges of the image where vignettes typically occur.
495Chapter 17 Making Image Adjustments