Operation Manual

A low value decreases the amount of detail, such as texture or grain, preserved in the
cloned pixels, and a high value increases the amount of detail.
Viewing the Corrected Image Without Spot & Patch Target Overlays
After retouching the blemishes in your image, you can view the corrected image with
the Spot & Patch target overlays turned off.
To view the corrected image with the Spot & Patch target overlays turned off
µ
Select the Selection tool in the tool strip or the Full Screen view toolbar (or press A).
The Spot & Patch target overlays disappear, but the effects of the Spot & Patch adjustment
remain visible.
To turn the Spot & Patch target overlays on again
µ
Click the Spot & Patch Tool button (with a patch icon) in the Spot & Patch area of the
Adjustments inspector or the Adjustments pane of the Inspector HUD.
The Spot & Patch target overlays reappear.
Moving Spot & Patch Target Overlays
Once placed, a Spot & Patch target overlay can always be moved.
To move a Spot & Patch target overlay
1 Make sure the Spot & Patch HUD is shown, then place the Spot & Patch target over the
Spot & Patch target overlay you want to move until a hand icon appears.
The hand icon indicates that you can drag the target overlay rather than place a new
one.
A hand icon appears to
indicate that you can
select the Spot & Patch
target overlay.
2 Drag the Spot & Patch target overlay to the appropriate position on the image.
Deleting Spot & Patch Target Overlays
You can delete a Spot & Patch target overlay at any time.
494 Chapter 17 Making Image Adjustments