Operation Manual

• Double-click the number in the Opacity value slider, then enter a value from 0 to 100
and press Return.
Use the Opacity slider and
value slider to adjust the
opacity of the cloned pixels
in the target overlay.
A low value decreases the opacity of the cloned pixels in the Spot & Patch target overlay,
and a high value increases the opacity.
Adjusting the Detail Within Spot & Patch Target Overlays
In addition to adjusting softness and opacity in Spot & Patch target overlays, you can
adjust the amount of detail, such as texture or grain, that is preserved in the cloned pixels.
You can adjust the
amount of detail in
the cloned pixels.
To adjust the amount of detail in cloned pixels in a Spot & Patch target overlay
µ
In the Spot & Patch area of the Adjustments inspector or the Adjustments pane of the
Inspector HUD, adjust the Detail parameter by doing one of the following:
• Drag the Detail slider.
• Click the left or right arrow in the Detail value slider, or drag in the value field.
• Double-click the number in the Detail value slider, then enter a value from 0 to 100
and press Return.
Use the Detail slider and value
slider to adjust the amount of
detail in the cloned pixels in
the target overlay.
493Chapter 17 Making Image Adjustments