Specifications

LED Cinema Display (24-inch) Take Apart — Logic Board 58
2010-02-08
Replacement
Reassembly is an exact
reversal of the steps.
Note: Connect 10 cables
with reverse side of MLB
facing you, then ip board
over and connect USB
uplink cable (#10).
1. power
2. blower
3. camera
4. sensor/blower
5. sensor/LCD
6. microphone
7. subwoofer
8. left speaker (4-pin)
9. right speaker (3-pin)
12. LCD function interface
Tip: Tape down the
USB uplink cable (#10)
to ensure it doesn’t get
pinched.
Shown for reference:
11. LED driver (backlight)
Important! For proper
USB port alignment,
connect any two USB
cables through the port
openings as you replace
the board and until the
board is securely fastened.