Specifications

2 - iBook (14.1 LCD 16 VRAM) Additional Proce-
Chip Standoff Installation Instructions
Installing the Chip Standoff
Warning: Always shut down the computer before opening it to avoid damaging its
internal components or causing injury. After you shut down the computer, the
internal components can be very hot. Let the computer cool down before
continuing.
1. Place the computer on a clean, flat surface.
2. Shut down the computer and wait thirty minutes before continuing.
3. Disconnect the power cord and any other cables connected to the computer.
4. Refer to the Take Apart chapter to remove the following parts to access the installed
logic board:
• Battery
• Bottom Case
• Bottom Shield
5. Locate the large chip on the bottom of the logic board. It has a square thermal pad
covering it.
Note: The following images are representative of the iBook models.