Specifications

REA Program Confirming Printer Operation - 23
After confirming printer operation, you must mark the
printer to show that it has undergone the REA work. The tool
you will use is a DecoColor® opaque paint marker (white
#300). This marker has been mailed to all service
providers.
Note : Try the marker on a test surface before applying a
mark to the printer. If you apply too much pressure, the
paint may flow too quickly and run along the face of the
chassis. Protect all adjacent surfaces.
4 Using light pressure, press a white dot onto the face of
the black chassis just to the left of where the cassette
slides in. The dot should be approximately one eighth
inch (2-10 mm) in diameter.
Location of
White Dot