User`s guide

RV100 Family User’s Guide 38
additional steps after the driver has been
installed. Do not install HYDRAVISION software
prior to installing this driver. The driver must be
installed first. After the driver has been installed,
proceed to the subsequent steps for
HYDRAVISION software installation.
Use the following instructions for a new
hardware and Appian driver installation OR for
a driver upgrade on a system with a previously
installed Appian RV100 based Windows 2000
driver. If upgrading from a previous driver,
skip step 1 and go straight to step 2.
1. Start your system. Upon Windows 2000 start up,
the new hardware will be automatically detected
and the Found New Hardware Wizard will
appear. You must click Cancel on the Found
New Hardware Wizard (up to two times for
Rushmore) before proceeding. If you are
prompted to restart your system, click No.
2. Insert the Appian RV100 based product
installation CD-ROM into the appropriate drive.
3. Double-click on My Computer, right-click on the
CD-ROM drive with the CD installed, and then
click Open.
4. Double-click on the folder named
AppianDrivers. Now double-click on the
Windows 2000 driver installation file to begin the
installation process. This is the executable (.exe)
file that begins with “w2k…”.


 NOTE: The latest driver installation file can also
be downloaded from Appian Graphics’ web site at
http://www.appian.com.
5. Now simply follow the prompts and instructions
in the driver installation wizard.
6. If the "Digital Signature Not Found" dialog
appears, click Yes for each time it appears.