User`s guide

19 Chapter 3: Software for Windows NT 4.0
16. Click OK if the path shown is the same as listed
in step 14. Otherwise, return to step 14 to select
the correct path.
17. Click on the Appian NT4.0 RV100 display driver
shown on the list and then click OK.
18. A warning box from Windows appears stating
that you are installing third-party software
drivers. Click Yes to proceed.
19. The Rushmore driver files are now installed, and
a message appears confirming successful
installation. Click OK.
20. Click Close to exit the Display Type window.
21. You are returned to the Display Properties
dialog box. Click Close to exit.
22. You will now be prompted by Windows to restart
your system. Click Yes.
23. Windows now restarts in single monitor mode.
You can change the resolution and refresh rate
for the Rushmore card from the Settings tab of
the Display Properties dialog box. You can
enable additional monitors from the Multi-
Monitor tab of the Display Properties dialog
box.
24. Now you can proceed to the section entitled
“Install HYDRAVISION

 and MultiDesk


Desktop Management Software in Windows
NT4.0” to install the HYDRAVISION and
MultiDesk software.
Install HYDRAVISION

 and
MultiDesk

 Desktop Management
Software in Windows NT4.0


 NOTE: HYDRAVISION and MultiDesk desktop
management software can only be installed after
the display driver has been installed. Do not