User`s guide

17 Chapter 3: Software for Windows NT 4.0
Install the Windows NT 4.0
Display Driver
⌦ WARNING! To avoid possible conflicts,
temporarily disable your virus protection
software during installation of this software.
You may reactivate virus protection after the
installation is complete.
⌦ You must have administrator rights to your
computer in order to install the display
drivers. If you do not have administrator
rights, please contact your system
administrator for assistance.
Prior to Windows NT4.0 driver installation, first make
sure the Rushmore board is correctly installed in
your system and that all monitors and cables are
properly connected.


 NOTE: The Windows NT4.0 driver does not
include HYDRAVISION desktop management
software. HYDRAVISION software installation
requires additional steps after the driver has been
installed. Do not install HYDRAVISION software
prior to installing this driver. The driver must be
installed first. After the driver has been installed,
proceed to the subsequent steps for
HYDRAVISION software installation.
Use the following instructions for a new
hardware and Appian driver installation OR for
a driver upgrade on a system with a previously
installed Appian RV100 based Windows NT4.0
driver.
1. Install your Appian Graphics RV100 based
hardware, if it is not already installed.
2. Boot your system into Windows NT 4.0. Insert
the Appian RV100 based product installation CD-
ROM.