User`s guide

11 Chapter 2: Get Started
Figure 3. Analog Device Cable Installation
Install the Rushmore
⌦ WARNING! Do not modify the jumpers on your
Rushmore card. A change to the factory set
jumper configuration could change the
performance of the Rushmore card or affect its
ability to function properly in your system.
To prepare your computer for installation of the
Rushmore card, perform the following steps:
1. Uninstall any previously installed graphics card
related software applications from the system.
Please refer to the graphics card manufacturer’s
specific instructions on how to do this. These
instructions can typically be found in the User’s
Guide or Manual for the graphics card, or possibly
on the card or system manufacture’s web site.
2. Turn off the computer and the power for all external
devices (monitor, printer, etc.).
3. Disconnect all cables from the rear of your
computer to give you more room to work. Note
where each cable connects so you can reconnect it
after installing the Rushmore card.