User`s guide

9 Chapter 2: Get Started
5. Replace and secure the computer cover.
6. Proceed to the monitor cabling section.
Typhoon Monitor Cabling
The Typhoon DVI card supports output to either
analog or digital display devices. To connect the
Typhoon DVI card to the desired display devices,
perform the following steps:
1. Attach the supplied DVI Y-cable to the installed
Typhoon DVI card and tighten the thumbscrews.
⌦ WARNING! Make sure the cable connector is
mated correctly to the connector on the
Typhoon card. It is possible to plug the cable
into the card incorrectly. This could cause
damage to the cable connector.
2. If you plan to output display from the Typhoon
DVI card to a DVI device, such as a digital flat
panel or digital projector, attach the supplied DVI
Y-cable directly to your DVI device cable(s) and
tighten the thumbscrews (Figure 2). Cable
installation is complete.