User`s guide

7 Chapter 2: Get Started
Hurricane Monitor Cabling
The Hurricane card provides support for one DVI
flat-panel or up to two VGA monitors using the
supplied DVI-to-VGA adapter.
Plug the VGA monitor cable into the card VGA
connector (the smaller of the two). Plug the DVI flat-
panel cable into the card DVI connector (the larger of
the two). If a second VGA monitor is desired, rather
than a DVI panel, connect the second VGA monitor
cable into the supplied DVI-to-VGA adapter (Figure 1),
and then plug the adapter into the card DVI connector.
Figure 1. Analog Adapter
Install the Typhoon
⌦ WARNING! Do not modify the jumper setting
on your Typhoon card. A change to the factory
set jumper configuration could change the
performance of the Typhoon card or affect its
ability to function properly in your system.
To prepare your computer for installation of the
Typhoon card, perform the following steps:
1. Uninstall any previously installed graphics card
related software applications from the system.
Please refer to the graphics card manufacturer’s
specific instructions on how to do this. These
instructions can typically be found in the User’s