User`s guide

RV100 Family User’s Guide 6
3. Disconnect all cables from the rear of your
computer to give you more room to work. Note
where each cable connects so you can reconnect it
after installing the Hurricane card.
4. Remove the cover mounting screws on the
computer. If necessary, refer to your system
instruction manual for information on removing the
computer cover.
5. Carefully remove the cover from the computer. The
system motherboard should now be in full view.
To install your Hurricane card, perform the
following steps:
6. Remove any previously installed graphics card(s)
from the system.
7. Locate an available PCI or AGP expansion slot for
the Hurricane card. If necessary, remove the
expansion slot cover and partner screw using the
appropriate tool.
⌦ WARNING! The Hurricane is static sensitive.
To avoid damage to the card from static
electricity, ground yourself before handling
the card by touching the metal frame on your
computer. This dissipates any static
electricity and prevents damage to sensitive
components.
8. Hold the Hurricane card by its top edge and slide it
into the available slot. The PCI or AGP bus
interface should fit into the appropriate slot. Make
sure the Hurricane card is firmly seated in the slot.
9. Once the Hurricane card is correctly seated in the
slot, secure it with the partner screw.
10. Replace and secure the computer cover.