User`s guide

5 Chapter 2: Get Started
Guide or Manual for the graphics card, or possibly
on the card or system manufacture’s web site.
2. Turn off the computer and the power for all external
devices (monitor, printer, etc.).
3. Disconnect all cables from the rear of your
computer to give you more room to work. Note
where each cable connects so you can reconnect it
after installing the Rushmore card.
4. Remove the cover-mounting screws on the
computer. If necessary, refer to your system
instruction manual for information on removing the
computer cover.
5. Carefully remove the cover from the computer. The
system motherboard should now be in full view.
6. Remove the previously installed graphics card if it
is no longer needed.
Install the Hurricane
⌦ WARNING! Do not modify the jumpers on your
Hurricane card. A change to the factory set
jumper configuration could change the
performance of the Hurricane card or affect its
ability to function properly in your system.
To prepare your computer for installation of the
Hurricane card, perform the following steps:
1. Uninstall any previously installed graphics card
related software applications from the system.
Please refer to the graphics card manufacturer’s
specific instructions on how to do this. These
instructions can typically be found in the User’s
Guide or Manual for the graphics card, or possibly
on the card or system manufacture’s web site.
2. Turn off the computer and the power for all external
devices (monitor, printer, etc.).