Installation Guide
Table Of Contents
AT-130 Installation Manual
600840-000064, rev 0.4 Page 4 of 5
2. About AT-130
The Appareo Asset Tracker, model AT-130 is a cost-effective, cellular, IP69K-rated asset
tracking device with ultra-long battery life and industrial operating temperature range (-40 ℃ to
+85 ℃).
3. Activating AT-130
In order to use AT-130, you need to activate it.
1. Peel off the clear label on the back of the unit shown below. Flip over the unit to remove
the magnet.
2. Put the magnet in the Device Activation slot for five seconds. Check your asset tracking
software to confirm that the device is activated (it should appear within 5-10 minutes if
the unit is outside with the logo facing up).
Once the device is activated, discard the magnet or return it to the initial holding slot.