Datasheet

APPA iMeter 5 Instruction
Card Meter Card
Symbols as marked on the meter and
Instruction card

Risk of electric shock

See instruction card

Equipment protected by double or
reinforced insulation
< Battery

Earth

Conforms to EU directives
E
Application around and removal from
hazardous live conductors is permitted
Do not discard this product or throw
away
.1. .2. .3.
.4. .5.
Auto Power Off
V
V
Display Hold
HOLD
HOLD
HOLDHOLD
The internal sounder will operate continuously
with LCD display flashing in two situations in the
Data Hold mode:
1. The Meter measure a signal different from
the LCD reading.
2. The measured signal is the same unit as the
LCD reading and is larger 50 counts than
the LCD reading.
Auto Range / Manual Range
RANGE
RANGE
RANGE
Selecting Function
Press “SELECT” key to select function.
.6.
Resistor / Capacitor / Continuity / Diode
HOLD RANGESELECT
AC V / DC / Hz / Duty
V
%
H
z
V
HOLD SELECT RANGE
Hz
%
 Caution
When connecting the test leads to the circuit
or device, connect the black lead first, then
connect the red lead ; when removing the test
leads, remove the red lead first, then remove
the black lead.
Meter 5i
Hz
%
RANGE
V
HOLD
V
SELECT
APPA TECHNOLOGY CORP.
9F, 119-1 Pao-Zong Rd.,
Shin-Tien, Taipei, 23115, Taiwan.
P.O.Box. 12-24 Shin-Tien, Taiwan.
Tel: [phone]
Fax: [phone]
E-mail : [e-mail]
http: //www.appatech.com
• For better measurement accuracy of small
value capacitance, subtract the residual
capacitance of the Meter and leads from
measurement.
• Under diode mode, LCD displays “bad” when
measuring a diode conducted at forward and
reverse bias.
Maintenance
Do not attempt to repair this Meter. It contains
no user-serviceable parts. Repair or servicing
should only be performed by qualified personnel.
Cleaning
Periodically wipe the case with a dry cloth and
detergent. Do not use abrasives or solvents.
Warning
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
Safety sheet
. . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
. . . . . . . . .
 Read First
 Safety Information
- Use the Meter only as specified in this manual
or the protection by the Meter might be
impaired.
- Always use proper terminals, switch position ,
and range for measurements.
- Do not apply more than the rated voltage,
as marked on Meter, between terminals or
between any terminal and earth ground.
- To avoid false readings that can lead to
electric shock and injury, replace battery as
soon as low battery indicator < appears.
- Disconnect circuit power and discharge all
high-voltage capacitors before testing resis
tance, continuity, diodes, or capacitance.
- Do not use Meter around explosive gas or
vapor.
- To reduce the risk of fire or electric shock
do not expose this product to rain or moisture.
Switch
Position
Select Key Actions
AutoSense DCV ACV
AutoSense
Ω ;
@
9
Ω ; @ 9
Hz%
Hz %
A
V
A
µA

µA

µA