Operation Manual

aponorm
®
Basis Control
10
1. Open the battery compartment
5
on the bottom
of the device.
2. Replace the batteries – ensure correct polarity
as shown by the symbols in the compartment.
3. To set date and time, follow the procedure
described in «Section 2.».

The memory retains all values although date
and time must be reset – the year number
therefore flashes automatically after the
batteries are replaced.
Which batteries and which procedure?

Use 4 new, long-life 1.5V, size AA alkaline
batteries. Use only batteries of one brand at
a time.

Do not use batteries beyond their date of
expiry.

Remove batteries if the device is not going to
be used for a prolonged period.
Using rechargeable batteries
You can also operate this device using rechargea-
ble batteries.

Only use «NiMH» type reusable batteries.

Batteries must be removed and recharged
when the flat battery symbol appears. They
should not remain inside the device as they
may become damaged (total discharge as a
result of low use of the device, even when
switched off).

Always remove the rechargeable batteries if
you do not intend to use the device for a week
or more.

Batteries cannot be charged in the blood
pressure monitor. Recharge batteries in an
external charger and observe the information
regarding charging, care and durability.
8. Using a Mains Adapter
You can operate this device using the aponorm
®
by microlife mains adapter (DC 6 V, 600 mA).

Only use the aponorm
®
by microlife mains
adapter available as an original accessory
appropriate for your supply voltage.

Ensure that neither the mains adapter or the
cable are damaged.
1. Plug the adapter cable into the mains adapter
socket
4
in the blood pressure monitor.
2. Plug the adapter plug into the wall socket.
When the mains adapter is connected, no battery
current is consumed.