User`s manual

Chapter 4 Configuring the Motherboard
TI6VGA User’s Manual 13
4.1 CPU Frequency Setting
The TI6VGA uses jumper-free technology in configuring the processor
on the motherboard. The system automatically detects the CPU bus
speed, 66MHz or 100MHz and sets the multiplier, or ratio, to 3X. The
BIOS (under Chipset Feature Setup) allows users to change the CPU
multiplier (3X, 3.5X, 4X, 4.5X, 5X) to set the correct or desired CPU
frequency.
IMPORTANT NOTE:
It is possible that the system will not
boot if the CPU has been changed. When this happens, turn off
the computer by pressing the power button and turn it on again
by pressing the
Insert
key and the power button
simultaneously. (Note to press the
Insert
key until an image
appears on the screen.) When the system is turned on, press the
Delete
key to enter BIOS Setup and configure the CPU speed.
4.2 Clear CMOS Select: JP6
Use JP6, a 3-pin header, to clear the contents of the CMOS RAM.
Do not clear the CMOS RAM unless it is absolutely necessary. You
will lose your password, etc.
JP6 Jumper Setting Function
1 2 3
pin 1-2: short Normal
1 2 3
pin 2-3: short Clear CMOS
NOTE
:
To clear CMOS, the ATX-power connector should be
disconnected from the motherboard.