Installation manual

Installation
Apollo MX20 Installation Manual
31
3. Obtain ICAO address of the aircraft from the FAA only if the UAT/ADS-B system is installed. The
ICAO address is a unique eight number code assigned to each aircraft. For U.S. registered aircraft, it
will be necessary to have a specific address code assigned. These address codes are presently issued
by:
Federal Aviation Administration
FAA Aircraft Registry
P.O. Box 25504
Oklahoma City, OK 73125
Tel: [phone]
Fax: [phone]
If the aircraft is registered in a country other than the United States, please contact the local aviation
authority of the country in which the aircraft is registered.
4. Enter in Flight ID. (Required if UAT/ADS-B system is installed.)
5. Enter Category Code. (Required if UAT/ADS-B system is installed.)
Category Code Aircraft Weight
Small < 15,500 lbs.
Medium 15,500 to 75,000 lbs.
Large 75,000 to 190,000 lbs.
Extra Large 190,000 to 300,000 lbs.
Heavy > 300,000 lbs.
High Performance > 5g acceleration and > 400 kts
6. Enter in Ownship Symbol (Single Engine, Twin, or Jet).
7. Set the Terrain Clearance Mode to Normal for all operations.
8. Demo Mode must be disabled for all aircraft installations.
9. Press Enter/Menu to confirm all settings.
10. After the 30-second waiting period, turn the MX20 power off to apply all configuration settings.
NOTE
MX20 power must be cycled before configuration changes will take affect.
After a configuration change, a message will appear on the screen telling you to wait 30 seconds
before turning off power. You may continue to make configuration changes without pausing;
however, do not turn off power to the MX20 until waiting 30 seconds after the last configuration/
setting change. The message will disappear when it is safe to cycle power.