Installation manual

Introduction
6 Apollo MX20 Installation Manual
1.6 SPECIAL TOOLS REQUIRED
Crimp Tool
A crimp tool meeting MIL specification M22520/1-01 and a positioner/locator are required to ensure
consistent, reliable crimp contact connections for the rear d-sub connectors. Examples of these tools
are shown below:
For pin P/N 245-0027
ITT Cannon Phone [phone]
1851 E. Deere Ave. Fax [phone]
Santa Ana, CA 92705-6500
Insertion tool: ITT part # 274-7006-000 (Desc. CIET-20HD)
Regular duty Crimp tool: ITT part # 995-0001-585 (Desc. M22520/1-01)
Regular duty Locator tool: ITT part # 995-0001-244 (Desc. TH25)
Heavy duty Crimp tool: ITT part # 995-0001-584 (Desc. M22520/2-01)
Heavy duty Locator tool: ITT part # 995-0001-604 (Desc. M22520/2-08)
For pin P/N 245-0059 (High Density Connector – I/O Only)
Astro Tool Corp Phone [phone]
21615 SW TV Highway Fax [phone]
Beaverton, OR 97006
Crimp tool: Astro Tool part # 615708
Positioner: Astro Tool part # 616356
1.7 LICENSE REQUIREMENTS
There are no license requirements for the MX20.
1.8 OPERATING INSTRUCTIONS
1.8.1 MX20
The MX20 User's Guide, UPS Aviation Technologies P/N 560-1026-xx, covers operation and pilot
interface. The MX20 Quick Reference Guide is P/N 561-0263-xx.
1.9 EXTERNAL DATA SOURCE COMPATIBILITY
External serial data sources intended for use with the MX20 should be checked for compatibility
before installation. Devices from other manufacturers or unlisted models are supported if they adhere
to the interface specifications provided in this manual. The list of supported devices is located in
Section 3.1.10 of this manual.