Installation manual

Introduction
Apollo MX20 Installation Manual
5
Table 1 - Installation Package Contents
Part # Description
Quantity w/o
GPS
424-0751
Quantity
w/ GPS
Quantity
w/ I/O
424-0753
Unit
430-0270-0xx Apollo MX20 Multifunction Display with GPS 1
430-0270-5xx Apollo MX20 Multifunction Display without GPS 1
430-0270-6xx Apollo MX20 I/O Traffic Multifunction Display 1
430-0270-7xx Apollo MX20 I/O Traffic/Radar Multifunction Display 1
MX20 Installation Kit
115-0007-00 GPS 1575 MHz 2:1 splitter 1
162-1008 Right angle coax plug 1
162-1060 TNC Connector 3
162-1577* 37-pin d-Sub 1 1 1
202-0001 Cable tie 4 4 4
204-0037 Edge grommet 6" 6" 6"
204-2100 Shoulder bushing 2
220-0637 6-32 Wing nut 1 1 1
240-0615 #6 Washer 2 2 2
224-0404 4-40 x 1/4 SS flat head Phillips machine screw 2 2 2
245-0027* Crimp contact for d-sub, 20 to 24 AWG wire 30 30 40
310-0429-xx MFD Mounting Tube 1 1 1
998-0048 3/32" hex driver 1 1 1
MX20 I/O Installation Kit
160-0138 62-pin d-Sub, high density 1
245-0059 Crimp contact for high density d-sub, 22 to 30 AWG wire 20
564-0076-0xx
Manual Kit
1 1 1
560-1025-xx MX20 Installation Guide 1 1 1
560-1026-xx MX20 User's Guide 1 1 1
561-0263 MX20 Quick Reference Guide 1 1 1
564-0078-0xx STC Kit (AFM & MDL) 1 1 1
Notes:
* Pin has a barrel over the contact. Use ITT Cannon tools.
Other Required Materials
The MX20 equipment is intended for use with standard aviation accessories. See section 1.9 for a list
of compatible equipment. The following items are required for the installation:
• Compatible position locating source, such as: Apollo GX50/55/60/65 GPS receiver, or
Apollo CNX-series receiver
• Compatible Serial Altitude Encoder