Installation manual

Serial Interface Specifications
56 Apollo GX50/60/65 Installation Manual
13
14
15
dddddddd
xxmmmmmm
xhhhhhhh
minutes and hundredths of minutes.
s = 0 East longitude, 1 West longitude
x = undefined
ddddddd = Longitude degrees
mmmmmm = Longitude minutes
hhhhhhh = Longitude hundredths of minutes
16 Cr
‘\r’ Item Terminator <0x0d>
ANNUNCIATOR OUTPUTS (WHEN EXTENDED DATA IS ENABLED ONLY)
Table 8 Annunciator Output Data
Id Item Format Len Description
a eampht 6
Annunciator Flags:
e = Approach Enabled { ‘-‘ (off) || ‘O’(on) }
a = Approach Active { ‘-‘ (off) || ‘O’(on) || ‘B’ (blink)}
m = Message { ‘-‘ (off) || ‘O’(on) || ‘B’ (blink)}
p = Parallel Track { ‘-‘ (off) || ‘O’(on) }
h = Hold { ‘-‘ (off) || ‘O’(on) || ‘B’ (blink)}
t = From/To {‘–‘ (off) || ‘T’ (To) || ‘F’ (From)}
c vDddd 5
CDI:
v = Nav Flag { ‘-‘ Flagged || ‘v’ Valid }
D = Needle { ‘C‘ Center || ‘L’ Left || ‘R’ Right }
ddd = Deflection Value ASCII (000 – 120)
v vDddd 5
VDI:
v = VDI Flag { ‘-‘ Flagged || ‘v’ Valid }
D = Needle { ‘C‘ Center || ‘U’ Up || ‘D’ Down }
ddd = Deflection Value ASCII (000 – 120)