Installation Guide

Customer Service: 1.888.229.2874 www.apolloow.com 5
PEX ANGLE CRIMP TOOL
HOW TO USE
Angle Crimp Tool
69PTKANG143 - 1/2"
69PTKANG144 - 3/4"
1. Cut tubing end squarely. Check for and
remove any burrs.
2. Slide crimp ring over end of tubing.
Insert tting into end of tubing until it
stops. Position the crimp ring 1/8" to
1/4" from the end of the tubing and
over the ribs of the tting.
4. Place the crimping end of tool around
the crimp ring. Push the handles
together rmly until the jaws are
completely closed. Repeat step 3 to
release the tool from the crimped ring.
5. Check for proper crimp with the Go/ No-
Go gauge. Crimped ring should slide
into the “Go” slot. Pressure test the
PEX tubing and inspect before burying
or normal use.
3. To open the jaws: In a continuous
motion, pull the moving handle apart,
down, then back towards the stationary
handle.
Moving
handle
Stationary handle
Apollo® PEX Crimp Rings
APXCR3810PK 3/8" 10 Pack
APXCR1210PK 1/2" 10 Pack
APXCR1225PK 1/2" 25 Pack
APXCR1250PK 1/2" 50 Pack
APXCR12100PK 1/2" 100 Pack
APXCR3410PK 3/4" 10 Pack
APXCR3425PK 3/4" 25 Pack
APXCR34100PK 3/4" 100 Pack
APXCR15PK 1" 5 Pack
APXCR125PK 1" 25 Pack
Apollo® PEX PRO Crimp Rings
APXCR12LT 1/2" 10 Pack
APXCR12LT25 1/2" 25 Pack
APXCR34LT 3/4" 10 Pack
APXCR34LT25 3/4" 25 Pack