Tus neeg siv phau ntawv

IG22.02 DS 43-98 22.06.16

Page 8

1. Attaching TV Swing Brackets to Back of TV (continued)_

Following these directions will insure that the TV is properly centered top to bottom in

your Apollo enclosure.

a. Select the notch on the TV Swing Bracket (see diagram A) based on the enclosure model size

(see Page 7)

b. Find the vertical center line of your TV by placing a tape measure vertically top to bottom on the

rear of the TV and mark the center of the TV with a pencil. (see diagram B)

c. Line up holes on TV swing bracket with TV VESA holes so that the appropriate notch in bracket

lines up with center line of TV (as close as possible).

d. Select the proper size metric screw with washers that fits the TV VESA holes (included with the TV

mount) and screw brackets in place. Be sure to tighten screws down to fit securely. If screws are

too long, use additional washers between bracket and screw head.