Tus neeg siv phau ntawv

IG22.02 DS 43-98 22.06.16

Page 12

7. Attach front cover

IMPORTANT: To power front bezel fans

Remove 10-32 flange nuts from studs on bottom of front

cover. Push front cover studs through the tabs in the back

cover and secure with flange nuts.

Carefully tighten to secure seal.

Flange on top of

rear panel fits into

top channel on front

cover.

a. Hold the cover at a slight tilt and carefully align from left to right so front cover is

centered over the flange of the rear cover. (See pictures below). Once aligned, drop

down cover so flange fits securely into channel. Cover should now freely pivot down to

close position.

Before closing front cover, plug

connector in back panel to

connector in bezel (as shown)

Tuck wires underneath TV before

closing front cover