Tus neeg siv phau ntawv

IG22.02 DS 43-98 22.06.16

Page 10

4. Attaching Mount Brackets to Rear of Back Panel

Models 43” to 86”

a. Use the set of VESA holes on the back panel which match the spacing of stiffener brackets on the

inside of the back panel, which also match the VESA pattern width of your TV. Use four (4) M6 X

20 metric screws, metal washers and rubber washers provided to fasten to the threated inserts on

the inside stiffener brackets.

b. Be sure that any unused VESA holes on the back panel are sealed with provided hole plugs.

5. Attaching the Back Panel to the Mount

NOTE: Be sure your mount is completely installed to your outside location and all cables

are run before proceeding.

a. Attach back panel to wall mount, lock the mount in the desired tilt or non-tilt position and tighten tilt

adjustment screws before hanging TV. Refer to directions included with your mount.

b. Run 9’ enclosure power cord through rectangular hole in back panel and plug into a GFCI

receptacle with an outdoor rated “in use” cover plate. (See safety statement)

c. Run your signal cable(s) from outside through rectangle opening in rear panel to be hooked up in

next step.

d. The fan control thermostat located on the back cover is

factory preset for the fans to turn the fans on when the

internal temperature of the enclosure reaches 30°C

(86°F). To test your fan operation be sure the enclosure

is plugged into AC power. Turn thermostat down to

lowest setting and once the fans turn on, return the

setting back to the 30C (86°F).

Last

IMPORTANT!

BE SURE THE O-RING RUBBER

WASHER IS PLACED BETWEEN THE

BACK OF THE ENCLOSURE AND THE

STAINLESS-STEEL WASHER TO

PREVENT WATER INTRUSION.