Installation Guide

4 www.apolloflow.com Customer Service: 1.888.229.2874
PEX CRIMP TOOL
HOW TO USE
Crimp Tools
69PTKH00143 - 1/2"
69PTKH00144 - 3/4"
69PTKH00185 - 1"
69PTKH0014C - 1/2" & 3/4"
69PTKH0015K - 3/8"-1"
1
To remove and replace crimp heads: For 69PTKH0015K only (Heads cannot be replaced on all other Apollo® crimp tools)
1. Cut tubing end squarely. Check for and
remove any burrs.
2. Slide crimp ring over end of tubing.
Insert fitting into end of tubing until it
stops. Position the crimp ring 1/8" to
1/4" from the end of the tubing and
over the ribs of the fitting.
3. Place the crimping end of tool around
the crimp ring and press the handles
together.
4. Check for proper crimp with the
Go/ No-Go gauge.
1. With the handles. fully
open, press side release
spring upward until the
hook is above the jaw pin.
3. With the side release
spring pressed upward,
slide new jaw into place
and release the spring.
2. Slide jaw out of position
and remove.
2 3
If you have a 69PTKH0015K that does not have spring
loaded jaws, but jaws that are secured with screws, sim-
ply loosen the screws located at the center of the jaws.
Remove the jaws and slide the jaws you need into place.
Replace the screws at the center of the jaws and tighten.
Apollo® PEX Crimp Rings
APXCR3810PK 3/8" 10 Pack
APXCR1210PK 1/2" 10 Pack
APXCR1225PK 1/2" 25 Pack
APXCR1250PK 1/2" 50 Pack
APXCR12100PK 1/2" 100 Pack
APXCR3410PK 3/4" 10 Pack
APXCR3425PK 3/4" 25 Pack
APXCR34100PK 3/4" 100 Pack
APXCR15PK 1" 5 Pack
APXCR125PK 1" 25 Pack
Apollo® PEX PRO Crimp Rings
APXCR12LT 1/2" 10 Pack
APXCR12LT25 1/2" 25 Pack
APXCR34LT 3/4" 10 Pack
APXCR34LT25 3/4" 25 Pack