Instructions / Assembly
INSTAllATION gUIdElINES
Delivery Temperature: Each valve is factory set for 120°F
outlet temperature with a 140°F hot water inlet temperature.
To ensure delivery of the desired mixed water temperature at
the outlet, the installer must adjust and verify the temperature
at the outlet by carefully following installation instructions.
Flush the system before installation: All debris should
be ushed from the plumbing system before installing Tank
Max. Not ushing the system properly may cause system
difculties.
• DO NOT subject valve to heat during installation or damage
may occur.
• DO NOT install valve on steam-supplied systems.
• DO NOT freeze valve. If the valve is installed where freezing
can occur, then suitable insulation must be provided to
prevent damage to the valve.
• DO NOT use excess thread sealant (liquid, tape, or any
other form) as this may cause the valve to fail.
Failure to comply with all aspects of the installation instructions may
result in unsafe performance.
All installations must comply with relevant state, provinicial, and
local codes and laws.