Specifications

Operation

Disassembly of the EK Siphon

Danger of Accidents!

Dismantle the EK Siphon only with unpressurized

vessel.

1. Close the pressure build-up valve (7).

2. Close the filling/withdrawal valve (3).

3. Detach the connected withdrawal line from the EK Siphon.

4. Open the waste gas/overflow (1) valve for relieving the

pressure of the vessel.

5. Loosen the wing screw (8) and remove the straining ring

(9) from the unpressurized tank.

6. Remove the EK Siphon (2) by pulling it out carefully from

the top and deposit it carefully.

7. Loosely insert the transport stopper.

Note

• Avoid any heavy mechanical strain.

• Do not carry out any assembly and disassembly

while the vessel is cold.

Assembly of the Transfer Hose

1. Screw the union nut (3) onto the connecting screwing (2) of

the filling/withdrawal valve (1).

2. Tighten the union nut (3) by means of an open-jawed

wrench; in doing so retain the hexagon (2) with a wrench.

3. If necessary, tighten the union nut (3) in cold condition.

Caution !

• Observe safety instructions.

• Use filling line with safety valve and pressure relief.

• Wear gloves and safety glasses.

• Protect the vessel from rolling away, tumbling down

and damage.

• The pressure in the supply – vessel must not be

higher than 1,3 bar

Note !

• Additional aggregates for filling and withdrawal have

to be adapted to the operating conditions of the

vessel.

• Filling has to take place outside or in a sufficient

ventilated room

Risk of suffocation

5.3 Assembly of the Transfer

Hose

5.4 Filling of the Vessel