User`s guide

APOGEE ELECTRONICS

Symphony64 PCI card – User’s Guide

Installing the X-Symphony card

Your X-Symphony card should include the following:

• 1 X-Symphony circuit card

• 1 X-Symphony Coverplate

• 2 aluminium standoffs

• 1 plastic standoff

1 Remove the top cover of the host interface.

2 Remove the Option Card coverplate, and set aside the screws for

later use.

3 Remove the two interface circuit board screws indicated at left, and

set them aside for later use

4 Install the two aluminium standoffs in the threaded holes vacated

by the screws.

5 On the X-Symphony card, install the plastic standoff in the hole

adjacent to the multi-pin motherboard connector.

6 Insert the Port connector end of the X-Symphony card through the

host unit back panel, and carefully place the multi-pin motherboard

connector in the mating connector found on the host interface

motherboard.

7 After verifying the alignment of the multi-pin and the mating con-

nectors, rmly press down on the X-Symphony card, over the con-

nector, until the pins are completely seated in the mating connector.

8 Re-install the circuit board screws from Step 3 in the locations

indicated below.

9 Install the X-Symphony coverplate, and secure it to the host inte-

face using two screws from Step 2.

10 Replace the top cover of the host interface.