User`s guide

APOGEE ELECTRONICS
20
Mini FireWire card – User’s Guide
5. Installing the Mini FireWire card
• If a USB card is already installed, remove the two USB card mounting
screws, and set them aside for a later step. Lift the USB card straight up
and out of the host interface.
• Line up the dual row of connector pins found under the Mini FireWire
card with the socket found on the host interface motherboard. Once you
have verifed that the pins are correctly inserted, press on the top of the
Mini FireWire card until the pins are completely
seated in the socket. (Re)-install the two card
mounting screws.
6. Installing the new rear panel, re-installing the top
• Slide the new rear panel on, ensuring that the FireWire connector
protrudes through the rear panel.
• Re-install all rear panel screws.
• Re-install the top cover and re-install all Allen screws.
Installing the Mini FireWire Card
Figure 5
Figure 5A
Figure 6
Figure 6A