User`s guide

APOGEE ELECTRONICS
18
Mini FireWire card – User’s Guide
Installing the Mini FireWire Card
Included in the Mini FireWire Update Kit: Additional tools needed
1 Mini FireWire card
small Phillips head screwdriver
1 back panel small flat blade screwdriver
1/8” Allen wrench
needle nose pliers
1 Apogee Software CD
1 Mini FireWire User’s Guide
(MiniMe only) 1 EPROM
1. Remove the 2 Allen screws found in the top corners of the
front panel
2. Remove the rear panel fasteners:
On a MiniMe remove:
4 Allen screws found in the rear panel corners
2 Phillips head screws holding the AES XLR connector
1 knurled washer holding the headphone connector
2 Phillips head screws holding each input XLR connector
On a MiniDAC remove:
4 Allen screws found in the rear panel corners
1 Phillips head screw holding the Coax/Optical connector
2 captive nuts holding the AES connector
1 knurled washer holding the Line Out connector
4 Phillips head screws holding each output XLR connector
Figure 2
Figure 1
Figure 2A