Specifications

Application Configuration 1

Select an AE5 for Output 1. Since the AE5 is a bi-amped preset, DLC24 Speaker Configuration Software automatically

fills Output 1 for the high frequency (HF) and Output 2 for the low frequency (LF). Polarity, Channel Membership, and

Input Selection for Output 2 are automatically selected based on the selections for Output 1.

Enable “Polarity” if required. Select “Ch A” for the Channel Membership. Once “Ch A” is selected, “In 1” will automatically

be selected for the Input Selection.

Select an AE12s2 for Output 3. Polarity (by default) is always enabled for subwoofers. Since the subwoofers in this

application will be from a separate aux-feed, select “Ch B” for Channel Membership. Once “Ch B” is chosen, “In 2” will

automatically be selected for the Input Selection.

Repeat for Output 4.

Type a description for both Channel A and Channel B. This description will appear in ADAM at the top of the

channel/loudspeaker panel window and the loudspeaker status window. It can be changed later in ADAM.

Mono Bi-Amp with Aux-Fed Subwoofer