Specifications

Application Configuration 2

Select an AE5 for Output 1. Since the AE5 is a bi-amped preset, DLC24 Speaker Configuration Software automatically

fills Output 1 for the high frequency (HF) and Output 2 for the low frequency (LF). Polarity, Channel Membership, and

Input Selection are automatically selected for Output 2 based on the selections for Output 1.

Enable “Polarity” if required. Select “Ch A” for the Channel Membership. Once “Ch A” is selected “In 1” will automatically

be selected for the Input Selection.

Select an AE5 for Output 3. Since the AE5 is a bi-amp preset, ADAM automatically fills Output 3 for the high frequency

(HF) and Output 4 for the low frequency (LF). Polarity, Channel Membership, and Input Selection are automatically

selected for Output 4 based on the selections for Output 3.

Enable “Polarity” if required. Select “Ch B” for the Channel Membership. Once “Ch B” is selected “In 2” will automatically

be selected for the Input Selection.

Type a description for both Channel A and Channel B. This description will appear in ADAM at the top of the

channel/loudspeaker panel window and the loudspeaker status window. It can be changed later in ADAM.

Stereo Bi-Amp

Panel Descriptions

DLC24 Rear Panel

1. IEC Inlet

100 – 240V, 1.1A, 50-60 Hz AC power receptacle.

2. Signal Ground Switch

Select whether the DLC24’s power supply ground is connected to chassis ground or “lifted”.

3. Control Selector Switch

Select Front or Remote Control.

4. Input Selector Switch

Select whether the DLC24 accepts analog or digital signals through the XLR inputs.

5. Reset Button

Recessed button offers both a soft and hard reset.

6. Amplifier Sense Returns Barrier Strip

Monitors the amplifier’s output voltages in order to engage protective limiters necessary

to prevent damage to speakers. The connections are labeled 1 through 4 and correspond

to the XLR outputs.

7. Output Signal Connections

Four balanced 3-pin XLR male signal output connectors.

8. Input Pin 1 Shield Switch

Select whether “IN 1” and “IN 2” Input’s Shield (Pin 1) is connected to chassis ground

or “lifted”.

9. Input Signal Connections

Two balanced 3-pin XLR female signal input connectors. Note: Only Input 1 is active

when Input Selector Switch is set to Digital.

10. RS-422 Input Connection

Remote PC connection is made via this 5-pin XLR female RS-422 port.

11. RS-422 Loop Connection

DLC24/PC network connection can be paralleled via this 5-pin XLR male RS-422 port,

making it possible to daisy-chain multiple DLC24 units.