Specifications

DLC24 Software Introduction
11
Updates to the DLC24 Speaker Configuration Software, ADAM software, and firmware may be downloaded from the
Apogee web site at www.apogee-sound.com / software .
Two software programs are included with the DLC24. The DLC24 Speaker Configuration Software, which enables the user
to custom configure the DLC24 for use with any Apogee speaker type and ADAM Software, which provides remote oper-
ational control and monitoring of the speaker system through a PC.
Note: Only one software program may be opened at a time.
DLC24 Speaker Configuration Software
The DLC24 Speaker Configuration Software enables the user to custom configure the DLC24 for use with any
Apogee speaker type. The DLC24 Speaker Configuration Software enables the user to select Apogee speaker types,
enable or disable the Polarity switch, select channels, and select inputs for each of the four outputs. Also, the user can
add channel descriptions for reference purposes in ADAM.
ADAM Software
The ADAM Software provides control and monitoring of the DLC24 through a PC, allowing the use of a wide variety of
features that would otherwise be unavailable to the user.
Note: In order to obtain full control via the ADAM software, the Control switch on the back of the unit
must be set to the “Remote” position. If set to “Remote”, the front panel controls are disabled.
Software Setup & Updates
Insert the CD-ROM into the CD drive of the PC. The CD should automatically begin the installation setup. However, if
the installation does not automatically begin, then go to the Start menu, select Run, and type “d:\setup”.
A welcome dialog box will appear. Click “Next”. A new dialog box will appear. Enter a “User Name” and an
“Organization” and check off one of the two user choices at the bottom of the dialog box (all users or single user) and
then click “Next.”
The next dialog box will ask about a destination folder for the software. It is recommended that all default folders be
used when installing the software. If a different installation folder is desired, click on “Change”. Otherwise, click on
“Next”. In the next dialog box click “Install”. After the software has been installed, click “Finish”. Updates to the software
and firmware can be found on the Apogee web site at www.apogee-sound.com .
Software