User Manual

Mixer Tab Window (Continued)
System Setup Tab Window
In most cases, Symphony hardware interface is part of a larger Mac-based audio system. Settings that encompass
the integrated hardware-software system are found on this tab window.
1.
Clock Source
- This drop down selects the clock source. The following sources may be selected:
•
Internal: Symphony is clocked from its internal crystal.
•
Word Clock: Symphony is clocked from an external signal connected to the rear panel BNC input.
•
SPDIF Coax, SPDIF Optical, ADAT, or SMUX: Symphony is clocked from a digital audio input. The clock
sources listed will vary depending on sample rate and optical input settings.
2.
Sample Rate
- Selects Symphony’s sample rate. In some cases this setting may be overridden by software
running on the computer (i.e. When a DAW session project is open).
3.
Peak Hold
- Sets the time that peak indications are held on software and front panel meters.
4.
Over Hold
- Sets the time that over indications are held on software and front panel meters.
5.
Keyboard
Volume Control
- The audio system may be configured so that the Mac keyboard volume controls set the
output level of Symphony’s speaker or headphone outputs.
SYMPHONY I/O MK II - USER’S GUIDE Page 38
8.
Software Return
- This stereo input channel draws signal from your software
audio application. Use the drop down menu to select which
stereo pair from software is heard through the mixer.
9.
Mixer Master
- This section of the mixer provides level control and metering
for the mixer’s output.