User Manual

Speaker & Headphone Controls
The following settings control the configuration and level of the rear panel analog outputs and front panel headphone
output.
Device Settings Tab Window
This tab only appears when the Mic Pre module, 2x6 I/O module, or an 8x8 I/O module with optical ports is installed.!
1.
Speaker Level
- Controls the speaker output level.
2.
Analog Out Format
- Sets the format of the analog outputs.
•
Line: Output 1/2 are configured as line outputs. Functions such as level
control, Mute, Dim, and Sum to Mono are disabled.
•
Stereo: Output 1/2 are configured as speaker outputs (with all monitor
functions available). Outputs 3-10 are configured as line outputs.
•
2 Speaker Sets: Output 1/2 and outputs 3/4 are configured as two pairs of
stereo outputs. Switch between the stereo pairs with the Speaker Select
buttons. These outputs are adjusted simultaneously with the Output
Controller knob.
•
3 Speaker Sets: Output 1-6 are configured as three pairs of stereo outputs.
Switch between the stereo pairs with the Speaker Select buttons. These
outputs are adjusted simultaneously with the Output Controller knob.
•
5.1, 7.1, 9.1: Outputs are configured as speaker outputs, suitable for
connection to a 5.1, 7.1 (8x8 or 16x16 I/O modules only), or 9.1 (16x16 I/O
module only) speaker system. These outputs are adjusted simultaneously
with the Output Controller knob.

3.
Headphone Level
Controls the output level of the corresponding headphone output.
4.
Mute
Select “M” to mute the speaker or headphone output.
5.
Dim
Select “D” to lower the speaker or headphone output level by 15dB. This
function is a convenient for briefly lowering the playback volume in the
speakers or headphones in order to hold a conversation without completely
muting the output.
6.
Sum to Mono
Select “∑” to combine the left and right channels of the speaker or
headphone outputs to mono. This function is useful to check mono
compatibility of a stereo signal.
SYMPHONY I/O MK II - USER’S GUIDE Page 34
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
1.
Optical
Format
- On modules with optical ports, select
between ADAT/SMUX, and SPDIF
protocols.
2.
Insert
Labels
- Type a description of the device(s)
connected to the Insert point of the
Mic Pre module.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20