User Manual

Using Symphony’s Low Latency Mixers
If you do not have any recording software open, or do not want to use it’s monitoring function due to issues such as
high latency (see “Understanding Latency” on page 40), then you can use one of the Low-Latency Maestro Mixers
built into Symphony to monitor your signal instead.
Low Latency Monitoring!
1.
Open Maestro and select the Output
Routing tab (or use the keyboard
combination [⌘+5])"
"
!
2.
To monitor using Speakers Connected to
outputs 1/2:
Click the left-most box next to “Mixer 1”. "
Now hardware Outputs Line 1/2 will draw
signal from the Maestro Mixer 1"
3.
To monitor using headphones:
Click the box to the far right of the Software Output
Mixer 1 and under Hardware Outputs HP “L/R”
This will cause your Headphones output to draw
signal from the Maestro Mixer 1.
NOTE: The Mixer’s location on the grid will vary based on the I/O s installed
You can contro l t h e a m o u n t o f i n p u t s i g n a l v e r s e s a u d i o p l a y b a c k y o u h e a r u s i n g t h e M a e s t ro M i x e r
controls:
1.
Select the Mixer tab (or use the keyboard
combination [⌘+6])."
"

2.
Select “Mixer 1”"
"
! "
3.
Adjust the level of input heard by adjusting the Input Fader, and level of audio
playback from a computer program by adjusting the Software Return Fader"
SYMPHONY I/O MK II - USER’S GUIDE Page 17