User Manual-for windows

Apogee Duet | User’s Guide for Windows
How to configure Low Latency Mixer
1. In your audio software, turn off software monitoring or simply mute the recording track.
2. In your audio software, set up a mix of all playback tracks and route the mix to Out 1-2 . It’s
suggested to set the audio software Master fader to 0 dB.
3. In Maestro, set the Output Selection to Mixer. This sends the output of Maestro’s low latency
mixer to the output assigned, rather than sending your audio software’s output.
4. After configuring Duet’s inputs, the input signal will route through the Mixer faders > to the
Mixer 1 Master > then to any of the Duet’s outputs that is assigned “Mixer 1”.
5. Use the Mixer’s Input and Playback 1-2 faders to establish a balance between the input and
playback signals. If you’ve found a good balance but the Mixer Master’s Over indicators light,
reduce the Mixer Master fader.
Page 25