How to Guide

Gardner-Gibson, Inc. • P.O. Box 5449 • Tampa, Florida 33675-5449
Phone: [phone] • Fax [phone] • www.apoc.com
I-18
SB-1 Self-Bond
Self-Adhered Roof Underlayment
damming”. Where back-nailing is required, be sure that all nails are covered by the overlapping next sheet. Roll entire membrane surface, particularly
end laps and side laps to ensure bonding of adhesive. Roller weight shall be 70 lb. for low slope and 28 lb. for steep slope. All penetrations must be
sealed using APOC Liquid Flash prior to installing primary roofing materials. Lower temperatures cause self-adhesive layer to lose adhesive quality.
Product applied at lower temperatures may be back-nailed to hold in position during application. Adhesion to deck and at laps will occur as ambient
temperature increase and after a return to warmer weather.
VENTILATION: This product is designed to be an air, water and vapor barrier and will retard the flow of moisture vapors when applied over the entire roof
deck. In this application, ensure the roof and attic are properly vented. Lack of ventilation can result in trapped moisture resulting in deck deterioration
or formation of mold. Always consult a design professional to address potential moisture entrapment and condensation issues. This can be in the form
of ridge vents, solar / power vents, continuous ceiling vapor barrier or other ventilation products. Proper ventilation will help alleviate these concerns. In
hot and arid climates, heat build-up can result in drying, cracking and premature aging of roofing materials and therefore venting is also required in hot
climates.
HANDLING PRECAUTIONS: Store product in the cargo area of vehicle. Product safety information required for safe use is not included. Before handling,
read product safety data sheets and container labels for safe use and for physical and health hazard information. Safety Data Sheets are available on the
APOC website at www.apoc.com, the APOC APP, by contacting APOC at [e-mail] or calling [phone].
LIMITED WARRANTY AND DISCLAIMER: To the best of our knowledge, the technical data contained herein is true and accurate at the date of issuance
and is subject to change without prior notice. User must contact APOC to verify correctness before specifying or ordering. No guarantee of accuracy is
given or implied. APOC Roofing Systems, Inc. (herein “APOC”) hereby warrants to the original purchaser, contingent upon original proof of purchase,
that this product will be free from any and all manufacturing defects that may materially and adversely affect the product’s performance for a period of
one (1) year from the date of original purchase (“Warranty Period”). Product must be applied in accordance with the proper application procedures,
and for the intended use as stated on the label. Proper preparation and drying conditions must be observed to achieve correct results. Should a
manufacturing defect materially and adversely affect this product’s performance, APOC shall, within its sole discretion and upon receipt of Purchaser’s
timely written notice within the Warranty Period, provide replacement product(s) or refund the purchase price of the defective product. THIS LIMITED
WARRANTY IS PURCHASER’S SOLE AND EXCLUSIVE WARRANTY AND REPLACES ALL OTHER WARRANTIES, CONDITIONS, REPRESENTATIONS
AND GUARANTEES, WHETHER EXPRESS OR IMPLIED, WHETHER BY STATUTE, AT LAW OR IN EQUITY, INCLUDING THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. This limited warranty does not cover labor or installation costs, water damage,
consequential damages or incidental damages. Under no circumstances will APOC be liable for any amount in excess of the product purchase price.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific
legal rights, and you may also have other rights which vary from state to state. Direct all warranty claims in writing along with original proof of purchase
to APOC, c/o Warranty Claims Department, P.O. Box 5449, Tampa, FL 33675. The exclusive venue for any legal action arising out of the purchase of
this product or this warranty shall be had in a court of competent jurisdiction within Hillsborough County, Florida. Florida law shall govern. For additional
Limited Warranty information, visit www.apoc.com/pages/warranty.
Manufacturing Location:
Springville, AL
For more information visit apoc.com or call technical at [phone], email [e-mail]
©2016 Gardner-Gibson, Inc.
Manufactured by / Fabricado por:
Gardner-Gibson, Inc.
P.O. Box 5449, Tampa, FL 33675
See SDS for more info
Page 2 of 2