Full Product Manual
LED Bathroom Mirror User Manual
IMPORTANT SAFETY INSTRUCTIONS
1)
Please carefully read these instructions before installation and retain for your future reference.
2)It is the company's policy to recommend the use of a qualified electrician for the installation of these fittings.
DANGER: To reduce the risk of electrical shock
1)For safety reasons always ensure that the mains supply switch is isolated before attempting installati on;
WARNING:To reduc e the risk of burns,fire, electrical shock or in
jury to persons:
1)We recommend that the surface fuse is withdrawn to prevent accidental switching on while work is in progress;
2)Close supervision is necessary when the mirror light is used by or near children,i
nvalids or disabled.
3)Use mirror light only for its intended use as described in these i nstruction. Do not use attachments not recommended by
the manufacturer.
4)Never operate the mirror light if it has a damaged wire . If it is not working properly.If it ha s been d
ropped or damaged
or dropped into water. Return the furnishing to a service center for examination or repair.
5)Keep the wire away form heated surfaces.
6)Never drop or insert any object into any opening.
7) This pr oduct contains glass parts. Care must be taken when fitting or handling these parts to prevent personal injury or
damage to the products.
8) Ensure the mounting surface is dry and strong enough to allow for the safe fitting of this fixture.
9) Ensure that current bui
lding regulations are adhe red to at all times should an additional e lectrica l supply be required.
10) Care must be taken before drilling fixing holes to avoid any existing wiring or paperwork that may be concealed;
11
) Finish the installation as following steps
：
12)Do not use outdoors
13) Mounting distance from ground do not exceed 1.5m
WARNING:
1
）
Risk of Electric Shock-Connect this furnishing to a properly grounded outlet only.
2) Grounding Instructions：
This product must be connected to a grounded m etal, permanent wiring
system, or an equipm ent-grounding conductor must be r un with the c ircuit conductors and connected to
the equipment-grounding terminal or lead on the product."
W
01