Specifications

10
3. Preparations
In order to use the Personal Tracker, the following preparations
should be carried out:
Prepare one operational GSM SIM card. Make sure that the SIM card can
operate without PIN protection and has GPRS with unrestricted Internet
access enabled (ask your GSM operator for APN and GPRS dial up
requirements). Empty the SMS storage of the SIM card using operational
GSM phone (please refer your GSM phone manual to do this).
Press the Power (INFO) button for 3 seconds to shut down the device.
1. Remove the back cover of the Personal
tracker by pressing up the battery release
lock and push the cover sideways.
2. Disconnect and remove the
battery. Insert the SIM card into
the SIM holder in the direction as
shown in picture.
3. Place the battery in the compartment
and reconnect it.
4. Replace the cover and let it snap in
completely.
Press the Power button to power up the device.
11
4. LED Status Description
X Device Status Indicators:
¾ If Geo-Fence LED flashes:
200m Geo-Fence has been activated
¾ If G-Force LED flashes:
G-Force alarm (fall-down or impact) has been activated
¾ Battery Status LED:
Flashes in short sequence when battery power is low
Stays on when battery is charging, turns off when
battery is fully charged
Y Operational Indicators
¾ GPS LED:
Stays on when device is searching for GPS signal
Flashes when device has GPS lock
¾ GSM LED flashes:
Device is registered to GSM network, able to send/
receive SMS and place or receive phone calls
¾ BUSY LED:
Device is dialing GPRS service. If connected, LED will
flash several times if connection to Control Base was
successful. Will repeat if not successful.
When SOS button is pressed for 2 seconds, BUSY LED
will turn on for sending data.
X Y
Geo-Fence
G-Force
Sensor
Battery
Status