User manual

APC-3X97A user manual
37
LVDS2 24*2 1280X1024
LVDS2 24*2 1440X900
LVDS2 24*2 1920X1080
Note: Due to limited address length of BIOS, only a portion of panel parameters are listed in
BIOS Setup. If the connected panel is not included in the parameter list, display problem will occur. In
this case, we need to adjust BIOS setup.
LCD Panel Brightness
This feature provides adjustable brightness control: LEVEL0~15.
3.5 Integrated Peripherals
Phoenix – AwardBIOS CMOS Setup Utility
Integrated Peripherals
► OnChip IDE Device [Press
Enter]
Item Help
► Onboard Device [Press
Enter]
► Super IO Device [Press
Enter]
Menu Level►
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Select "OnChip IDE Device" item and press "Enter" for setup of IDE devices, as shown by the
following figure:
Phoenix – AwardBIOS CMOS Setup Utility
OnChip IDE Device
IDE HDD Block Mode [Enabled]
Item Help
IDE DMA Transfer access [Enabled]
On-Chip Primary PCI IDE [Enabled]
Menu Level►
IDE Primary Master PIO [Auto]
IDE Primary Slave PIO [Auto]
IDE Primary Master UDMA [Auto]
IDE Primary Slave UDMA [Auto]
On-Chip Secondary PCI IDE [Enabled]
IDE Secondary Master PIO [Auto]
IDE Secondary Slave PIO [Auto]