User manual

APC-3X92X User Manual
76
5.2.3 Software Functions (Resistive Touch)
Upon rebooting, the computer automatically finds the new 6000 controller board. The touch screen is
connected but not calibrated. Follow the procedures below to carry out calibration.
1. After installation, click the PenMount Monitor icon “PM” in the menu bar.
2. When the PenMount Control Panel appears, select a device to “Calibrate.”
PenMount Control Panel
The functions of the PenMount Control Panel are Device, Multiple Monitors ,Tools and About,
which are explained in the following sections.
Device
In this window, you can find out that how many devices be detected on your system.
Calibrate
This function offers two ways to calibrate your touch screen. „Standard Calibration‟ adjusts most touch
screens. „Advanced Calibration‟ adjusts aging touch screens.
Standard Calibration
Click this button and arrows appear
pointing to red squares. Use your
finger or stylus to touch the red
squares in sequence. After the fifth
red point calibration is complete. To